Huawei OptiXstar EG8145X6 User Manual

3 Indicator Description
Indicator Status Description
Power Steady on The ONT is powered on.
O The power supply is cut o.
PON/LOS See the following table.
LAN1-
LAN4
Steady on The Ethernet connection is in the normal state.
Blinking Data is being transmitted over the Ethernet port.
O The Ethernet connection is not set up.
TEL Steady on The ONT is registered with the softswitch but no
service ows are transmitted.
Blinks twice a
second
The ONT is registered with the softswitch, and
data is being transmitted onthe port.
Blinks once
every 2
seconds
The ONT fails to be registered with the softswitch.
O The POTS port is disabled.
USB Steady on The USB port is connected and working in the
host mode, but no data is transmitted.
Blinking Data is being transmitted on the USB port.
O The system is not powered on or the USB port is
not connected.
WLAN Steady on The WLAN function is enabled.
Blinking Data is being transmitted over the WLAN port.
Huawei OptiXstar EG8145X6
Quick Start for QR code 3 Indicator Description
Issue 01 (2020-07-01) Copyright © Huawei Technologies Co., Ltd. 6

Huawei OptiXstar EG8145X6 Specifications

General

Power Supply	12 V DC, 1.5 A
Ethernet Ports	4 x 10/100/1000 Mbps
PON Interface	GPON
USB Ports	1 x USB 2.0
Frequency Bands	2.4 GHz, 5 GHz
Antennas	4
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to +70°C
Operating Humidity	5% to 95% (non-condensing)
Downstream Rate	2.5 Gbps
Upstream Rate	1.25 Gbps