Networking Requirements
As shown in Figure 5-5, SwitchA is newly added to the network. SwitchA and SwitchB are
connected through a trunk link. To enable the network administrator to manage SwitchA
remotely, you need to configure the Telnet service and set the device name on SwitchA.
Figure 5-5 Networking diagram of managing SwitchA through Telnet
Configuration Roadmap
The configuration roadmap is as follows:
1. Log in to SwitchA through the console interface.
2. Set the device name.
3. Configure a management VLAN.
4. On SwitchA, set the type of the interface that connects SwitchA and SwitchB to trunk. Add
the interface to the management VLAN in trunk mode.
5. Configure the management IP address of SwitchA.
6. Configure the Telnet service.
Data Preparation
To complete the configuration, you need the following data:
l ID of the management VLAN
l Management IP address of SwitchA
l Number of the interface that connects SwitchA and SwitchB on SwitchA
l Authentication mode, user name, and password
Configuration Procedure
1. Log in to SwitchA through the console port. For details, see Logging In to the Switch
Through the Console Interface.
S3700&S5700&S6700 Series Ethernet Switches
Quick Start 5 Logging in to the Device
Issue 02 (2012-09-10) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
59
To Next Page
Loading...
Need help?
General