For information on the complete setup in the application, please visit our USING THE APP [2] section.
HPC - Using Hunter Remotes
The HPC face panel quickly and easily upgrades Pro-C® controllers (PC400 models manufactured
since March 2014) to next-generation smart controllers via the Hydrawise platform. In addition, it lets
contractors continue using their Roam and Roam XL remotes for quick on-site management. HCC is
also compatible with Hunter’s ROAM and ROAM XL remotes, allowing for fast and reliable manual
operation in the field from long-range distances without the need for a smartphone. There is no need
to remove the smart port adapter from the controllers when doing a facepack upgrade.
Compatible models include all Hunter remotes: SRR, ICR, ROAM, and the ROAM-XL.
If the Smartport is not installed on the controller, see illustrations below for wiring instructions.
Note: Any extension of the wiring on the SmartPort may result in an error message in
the controller display and possible malfunction of the remote unit due to radio interference. In
some situations, lengthening of the harness may work fine, in others it may not work at all (it is
site specific). In either case, extending the wiring harness should be done using shielded cable to
minimize the possible effects of electrical noise. For easiest installation, order the Hunter SmartPort
shielded cable wiring harness. (P/N ROAM-SCWH) with a full 25' (7.6 meters) of
shielded cable.
Wiring
1. Bottom 24 VAC terminal - Red wire
2. Second 24 VAC terminal - White wire
3. Remote terminal - Blue wire
Smart Port Wiring
To Next Page
Loading...
Need help?
General
