Hunter Universal Fan and Light Remote Control User Manual

44092-01 • 12/15/10 • Hunter Fan Company
8
5 • Programming the Remote
Programming the Remote:
The remote transmitter and remote receiver should already be programmed to work together.
• If you want the remote to control a second fan, or you want to re-progam remote:
1. Turn the power to the second fan (or the fan you want to re-program) OFF at the wall switch.
Then, turn it back ON.
2. Within 30 seconds, press the 1 (Fan Low) and 3 (Fan High) buttons on the transmitter
together and hold them down for 5 seconds. The LED light on the transmitter will blink 3
times to conrm.
3. The fan’s light will turn OFF and the fan will turn ON at low speed to further conrm the
programming has taken effect.
4. Repeat this process to correct interference with other devices, or to program additional fans
to this remote.
• If there is any fan in your home you do NOT want programmed to this remote, make sure the power
to that fan is turned OFF at its wall switch while programming the remote.
Fan Operation:
For best fan operation: Start the fan on High (3), and then select the
desired speed.
• Press the High (3), Medium (2), or Low (1) speed buttons to turn the ceiling fan ON at the desired
speed.
• Press the fan “0” key to turn the ceiling fan OFF.
*Hold down fan speed
buttons 1 & 3 together for
5 seconds to program the
remote control
Fan High
Fan Low
Fan
Medium
Fan Off
Figure 9

Hunter Universal Fan and Light Remote Control Specifications

General

Brand	Hunter
Model	Universal Fan and Light Remote Control
Category	Remote Control
Language	English