Husky C302H User Manual

24
Problem Possible Cause Solution
The compressor does not
run.
□ There is a loss of power or
the motor is overheated.
□ Check for proper use of extension cord.
□ There is no power to the
unit.
□ Check to be sure the unit is plugged in.
□ The circuit breaker has
tripped or a fuse has blown
at the main power source.
□ Check the fuse/breaker.
□ The thermal overload
protector is actuated.
□ Turn the air compressor OFF ( O ).
□ Unplug air compressor and wait until
compressor cools down.
□ Plug the air compressor into an approved
outlet.
□ Depress the red reset button on the
motor.
□ Turn the air compressor to the AUTO
position (I).
□ The pressure switch is bad. □ Bring the compressor to a service center.
□ The compressor has reached
automatic shutoff pressure.
□ Release the air from the tank until the
compressor restarts automatically.
The motor hums while
running slowly, or it doesn’t
run at all.
□ There is low voltage from
the power source.
□ Call an electrician.
□ The wrong gauge wire or
length of extension cord is
being used.
□ Check for proper gauge wire and cord
length.
□ There is a shorted or open
motor wiring.
□ Bring the compressor to a service center.
□ There is a defective check
valve or unloader.
□ Bring the compressor to a service center.
The fuses blow or circuit
breaker trips repeatedly.
□ The incorrect fuse type is
being used.
□ Check for the proper fuse.
□ Use a time-delay fuse. Disconnect other
electrical appliances from the circuit
or operate the compressor on its own
branch circuit.
□ The wrong gauge wire or
length of extension cord
is used.
□ Check for the proper gauge wire and
cord length.
□ There is a defective check
valve or unloader.
□ Bring the compressor to a service center.
Troubleshooting
C302H_HUSKY_manual_5-15-ENG.indd 24 6/10/15 12:05 PM

Husky C302H Specifications

General

Brand	Husky
Model	C302H
Category	Air Compressor
Language	English