11 HUSKYTOOLS.com
Please contact 1-888-43-HUSKY for further assistance.
Pre-Operation (continued)
ATTACHING THE HOSE
WARNING: Do not attempt to modify this
product or create accessories not recommended
for use with this product. Any such alteration
or modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury.
WARNING: Do not attach air chuck or other
tool to the open end of the hose until start-up has
been completed.
WARNING: Do not allow familiarity with
products to make you careless. Remember that a
careless fraction of a second is sufficient to inflict
serious injury.
WARNING: Always wear safety goggles or
safety glasses with side shields when operating
power tools. Failure to do so could result in
objects being thrown into your eyes resulting in
possible serious injury.
The compressor is assembled at the factory and ready for
use. Check all components to ensure secure assembly.
(such as: rubber feet, wheels, handle, quick connects,
gages, safety valve, air filter, drain valve, etc.)
□ Make sure the power to the air compressor is
disconnected.
□ Apply thread tape to the threaded connections
of the hose (not included), and attach the quick
coupler to the hose using a wrench (not included).
□ Apply the thread tape to the threaded connections
of the male plug, and attach the male plug to the
hose using a wrench.
□ Rotate the pressure regulator knob (1) fully
counterclockwise.
□ Insert the hose adapter end of the air hose (2) into
the female coupler end in the air compressor (3).
1
3
2
To Next Page
Loading...
Need help?
General
