EasyManuals Logo
Home>Husky>Air Compressor>C601H

Husky C601H User Manual

Husky C601H
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
5
HUSKYTOOLS.COM
Please contact 1-888-43-HUSKY for further assistance.
pts-205109-051012, pts-2053019-053012, pts-206067-060612
WARNING: Risk of electrical
shock. Improper electrical
grounding can result in
electrical shock. The wiring
should be done by a qualied
electrician.
WARNING: Risk of electrical
shock. Electrical wiring must
be located away from hot
surfaces such as manifold
assembly, compressor outlet
tubes, heads, or cylinders.
CAUTION: Improper electrical
installation of this product may
void its warranty and your re
insurance. Have circuit wiring
performed by qualied personnel
such as a licensed electrician
who is familiar with the current
national electrical code and any
prevailing local electrical codes.
A qualied electrician needs to knows the
following before wiring:
Safety Information (continued)
1. The amperage rating of the electrical
box should be adequate. Refer to the
Specications for this information.
2. The supply line should have the same
electrical characteristics (voltage, cycle,
phase) as the motor. Refer to the motor
nameplate, on side of motor, for this
information.
NOTICE: The wiring used
must be rated for the motor
nameplate voltage, plus or minus
10%. Refer to local codes for
recommended wire sizes, correct
wire size, and maximum wire
run; undersize wire causes high
amp draw and overheating to the
motor.
ELECTRICAL SAFETY
(GROUNDING INSTRUCTIONS)
This product should be connected to a
metallic, permanent wiring system, or an
equipment-grounding terminal or lead on
the product.
Air Distribution System
WARNING: Risk of bursting.
Plastic or PVC pipe is not
designed for use with
compressed air. Regardless of
its indicated pressure rating,
plastic pipe can burst from air
pressure. Use only metal pipe
for air distribution lines.
Figure 1 represents a typical air distribution
system. The following are tips to remember
when setting up the air compressor’s air
distribution system.
NOTICE: Compressed air from
oil lube air compressors will
contain wa ter condensation
and oil mist. Several drains,
traps and lters will be needed
to supply air without water
(including aerosols) or oil to
spray equipment, air tools and
accessories requiring ltered
air. Always read the in struc tions
for the air tools and accessories
being used.
• Usepipethatisthesamesizeastheair
tank outlet. Piping that is too small will
restrict the ow of air.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Husky C601H and is the answer not in the manual?

Husky C601H Specifications

General IconGeneral
BrandHusky
ModelC601H
CategoryAir Compressor
LanguageEnglish

Related product manuals