Husqvarna 105 User Manual

English - 29
3. INSTALLATION
Laying the boundary wire in towards the charging
station
The boundary wire must be laid in line with the rear
end of the charging station and at least 1.5 metres
straight out to the right and left of the station. See the
illustration. If the boundary wire is laid in any other
way, the robotic lawnmower may find it hard to find
the charging station.
Splicing the boundary wire
Use an original coupler if the boundary wire is not
long enough and needs to be spliced. It is waterproof
and gives a reliable electrical connection.
Insert both wire ends in the coupler. Check that the
wires are fully inserted into the coupler so that the
ends are visible through the transparent area on the
other side of the coupler. Now press down the button
on top of the coupler fully. Use a polygrip to
completely press down the button on the coupler.
IMPORTANT INFORMATION
Twinned cables, or a screw terminal block
that is insulated with insulation tape are not
satisfactory splices. Soil moisture will cause
the leads to oxidise and after a while result in
a broken circuit.
3018-072
3018-055

Husqvarna 105 Specifications

General

Model	105
Cutting Height Min	20 mm
Cutting Height Max	50 mm
Battery Type	Li-ion
Typical Charging Time	50 min
Typical Mowing Time per Charge	70 min
Maximum Incline Inside Working Area	25 %
Type	Robotic Lawn Mower
Working area capacity	600 m²
Maximum incline within the working area	25%
Cutting system	3 pivoting razor blades
Sound level Measured	58 dB(A)
Battery capacity	2.1 Ah
Cutting Width	17 cm
Weight	6.7 kg