30 - English
3. INSTALLATION
3.5 Connecting the boundary wire
Connect the boundary wire to the charging station:
1. Place the wire ends in the connector:
• Open the connector.
• Place the wire in the connector grip.
2. Press the connectors together using a pair of
pliers. Press until you hear a click.
3. Cut off any excess boundary wire 1 or
2 centimetres above each connector.
4. Press the connector onto the contact pin,
marked AL (left) and AR (right), on the charging
station.
IMPORTANT INFORMATION
The boundary wire must not be crossed when
connecting it to the charging station. The
right hand wire end must be connected to the
right hand pin on the charging station and
the left hand wire end to the left pin.
IMPORTANT INFORMATION
The right hand connector must be connected
to the right hand metal pin on the charging
station and the left hand wire end to the left
connector.
3012-284
3012-264
3012-265
3012-996
To Next Page
Loading...
Need help?
General
