STARTING AND STOPPING
until engine attempts to start (or maximum 3
pulls).
4. If the engine starts or attempts to start, push
the choke lever down to the run position.
5. Keep on pulling the cord powerfully until the
engine starts.
6. Once the engine starts, allow the engine to
warm up for 30 seconds before applying full
throttle.
Warm engine
1. Primer bulb: Press the air purge diaphragm
repeatedly until fuel begins to fill the diaphragm
(about 10 times). The diaphragm need not be
completely filled.
2. Repeat pulling the cord until engine attempts to
start (or maximum 3 pulls).
Stopping
Stop the engine by pushing and releasing the stop
switch.
CAUTION! The stop switch automatically
returns to the start position. In order to prevent
unintentional starting, the spark plug cap must
be removed from the spark plug when
assembling, checking and/or performing
maintenance.
WARNING: When the engine is started
with the choke in the closed position the
cutting attachment will start to rotate
immediately.
To Next Page
Loading...
Need help?
General
