Husqvarna 150BT User Manual

English
18
 STARTING ENGINE
IMPORTANT
• Avoid operating the blower with the flexible tube and swivel joint
disconnected. That will reduce the cooling air and the engine could be
damaged by overheating.
1. Push the primer bulb until fuel flows out in the clear tube.
2. When the engine is cool, close the choke.
(1) Choke Lever
(2) Primer Bulb
(3) OPEN
(4) CLOSE
3. Set the throttle lever position.
[130BT] [150BT] [170BT] [180BT]
Idling About 1/3 Open
(1) Full Throttle
(2) About 1/3 Open
(3) Idling
(4) STOP
4. To start, hold the top of the blower firmly with your left hand. Pull the starter knob
slowly until you feel it engage and then give it a vigorous strong pull.
IMPORTANT
• Never twist the starter cord around your hand.
• Avoid pulling the starter rope out to its full extent and allowing the starter rope
to snap back. This will prevent premature damage to the starter.
• Do not let a person stand near the blower or the exhaust port.
5. Once the engine is running, gradually open the choke if it was set closed, and let the
engine run at idle speed for a minute to warm it up.
NOTE
When the engine fails to start after several attempts due to overchoking, open
the choke and repeat pulling the rope.
WARNING
Air comes out as soon as the engine is started, even at idle speed.
(1)
(2)
(3)
(4)
F13
F14
[130BT]
(1)
(2)
(3)
(4)
F15
[170BT] [180BT]
(1)
(2)
(4)
(3)
[150BT]
(1)
(2)
(3)
(4)
F16
F17
Operation
130BT&180BTEU‑65.fmPage18Friday,December7,20074:00PM

Husqvarna 150BT Specifications

General

Engine Displacement	50.2 cc
Fuel Tank Volume	42.27 fl oz
Engine Type	2-stroke
Sound Power Level	104 dB(A)
Maximum Air Volume	434.37 cfm
Dry Weight	4.7 kg
Maximum Air Speed	75 m/s