Husqvarna 562XP Mark II User Manual

5. Make sure that the edges of the cutters point forward
on the top edge of the guide bar.
6. Align the hole in the guide bar with the chain adjuster
pin and install the clutch cover.
7. Tighten the bar nuts finger tight.
8. Tighten the saw chain. Refer to To adjust the tension
of the saw chain on page 28 for instructions.
9. Tighten the bar nuts.
Note: Some models have only one bar nut.
To assemble a spiked bumper
To assemble a spiked bumper, speak to your servicing
dealer.
Operation
Introduction
WARNING: Read and understand the
safety chapter before you use the product.
To do a function check before you use
the product
1. Make sure that the chain brake operates correctly
and that it is not damaged.
2. Make sure that the right hand guard is not damaged.
3. Make sure that the throttle lockout operates correctly
and that it is not damaged.
4. Make sure that the start/stop switch operates
correctly and that it is not damaged.
5. Make sure that there is no oil on the handles.
6. Make sure that the vibration damping system
operates correctly and that it is not damaged.
7. Make sure that the muffler is correctly attached and
that it is not damaged.
8. Make sure that all parts of the product are correctly
attached and not damaged or missing.
9. Make sure that the chain catcher is correctly
attached.
10. Do a check of the saw chain tension.
7
10
9
1
2
3
6,8
4
10 2053 - 001 - 18.04.2023

Husqvarna 562XP Mark II Specifications

General

Engine Power	3.5 kW
Cylinder Displacement	59.8 cm³
Maximum Power Speed	9600 rpm
Fuel Tank Volume	0.65 l
Oil Tank Volume	0.35 l
Chain Pitch	3/8"
Weight (excl. cutting equipment)	6.1 kg
Chain gauge	0.058 in