Accessories
Recommended cutting equipment
A specific chainsaw model has to be evaluated with
the cutting equipment to be recommended and fulfill the
requirements in ANSI B175.1-2012 (Internal Combustion
Engine-Powered Hand-Held Chainsaws - Safety and
Environmental Requirements) and Canadian Standards
CSA Z62.1-15 (Chainsaws) and CSA Z62.3-11 (R2016)
(Chainsaw kickback).
Chainsaw models Husqvarna 562XP Mark II, 562XPG
Mark II met the safety requirements in ANSI
B175.1-2012 and Canadian Standards Association CSA
Z62.1-15 (Chainsaws) and CSA Z62.3-11 (R2016)
(Chainsaw kickback), when equipped with the below
listed saw chain and guide bar combination(s).
Note: Other chainsaw models may not meet the
kickback requirements when equipped with the listed
guide bar and saw chain combinations.
We recommend only to use the listed guide bar and saw
chain combinations.
Low kickback saw chain
A saw chain that is designated as Low kickback saw
chain, meets the low kickback requirement specified in
ANSI B175.1-2012.
Kickback and guide bar nose radius
For sprocket nose bars the nose radius is specified by
the number of teeth, such as 10T. For solid guide bars
the nose radius is specified by the dimension of the
nose radius. For a given guide bar length, you can use a
guide bar with smaller nose radius than given.
Approved cutting equipment for Husqvarna 562 XP Mark II, 562 XPG Mark II:
Guide bar Saw chain
Length, in/cm Pitch, in Gauge, in/mm Max. nose ra-
dius
Type Length, drive
links (no.)
Low kickback
15/38 3/8 0.058/1.5 11T or 34 mm Husqvarna
C85
56
16/40 60
18/45 68
20/50 72
24/60 84
28/70 92
16/40 3/8 0.050/1.3 11T Husqvarna
C83
60
18/45 11T or 34 mm 68
20/50 72
24/60 84
28/70 11T 92
24/60 3/8 0.058/1.5 11T or 34 mm Husqvarna
C85S
84
28/70 92
24/60 3/8 0.050/1.3 11T or 34 mm Husqvarna
C83S
Husqvarna
C83SK
84
28/70 11T 92
2053 - 001 - 18.04.2023 35
To Next Page
Loading...
Need help?
General
