3012-576
3012-575
English - 62
MENU FUNCTIONS
Change the name of a Prole
Prole names can be changed so it is easier to remember
what settings have been saved in the respective prole.
• Select the Prole name to be changed
• Press OK
• Select Rename in the menu and press OK.
• Move the cursor with the arrow keys. Press OK to
select a letter. Press BACK to save the new name.
• Prole names can be seen in the Settings - Proles
menu. The name of the selected prole can also be
seen on the start page.
Use a Prole
Do the following to activate and use a prole and thereby
use the settings that have been saved.
• Mark the prole to activate.
• Press OK.
• Select Select and press OK.
The robotic lawnmower will now use the settings that
were saved in the prole.
One Automower
®
for several yards
The unique coupling between mower and charging station
is saved in the proles. This allows up to three different
charging stations to be coupled to the same robotic
lawnmower.
Coupling a new charging station to the robotic
lawnmower:
• First save a prole to be used with the original
charging station.
• Then place the mower in the new charging station
being coupled to the mower.
• Select New loop signal, see 6.5 Security on page 47.
• Save a prole for the new charging station.
In order to use the robotic lawnmower in the original
charging station, the rst prole must now be selected. In
order to use the robotic lawnmower in the new charging
station, the new prole must now be selected.
To give the best function, GPS assisted navigation should
be disabled for all extra installations and only be used for
the main installation. To turn off GPS assisted navigation,
see 6.8 Installation on page 51.
1157866-26,420,430X,450X,EN_160314.indd 62 2016-03-14 16:59:45
To Next Page
Loading...
Need help?
General
