MAINTENANCE
40
1
2
1¾"
Parking Brake
Visually check that no damage is found on the lever,
links, or switch belonging to the parking brake.
Perform a standstill test and check that there is
sufficient braking action.
IMPORTANT INFORMATION
The machine must be standing still when
applying the parking brake.
8065-006
Parking brake
WARNING!
Faulty adjustment result in reduced
braking ability and can cause an
accident.
Parking Brake Adjustments
1. Using a jack stand, raise the rear of the mower up
off the ground. Make sure the machine is securely
supported.
2. Remove the rear tire assemblies.
3. Release the park brake.
4. Measure the distance from the swivel to the
washer. (See Illustration). The measurement
should be 1¾" on both the right and left side
brake linkage assemblies.
8065-051
1. Swivel
2. Washer
Parking brake adjustment
To Next Page
Loading...
Need help?
General
