HUSTLER FasTrak User Manual

605596CE 4-7 REV C
When mounting blades, rotate them after installation to
ensure blade tips do not touch each other or sides of the
mower.
Mower Blade Options
The following is a list of the approved mower blade options
that are available from Hustler
®
Turf Equipment for this
mower.
Seat Adjustment
IMPORTANT: Any maintenance operation that requires
the removal of safety covers must be performed by a trained
service technician.
The seat on the mower can be adjusted forward and rear-
ward by sliding the seat release lever until a comfortable
operating position is attained.
Figure 4-12
Steering Control Lever Adjustment
The steering control levers can be adjusted for operator
comfort.
A. To pivot the upper control levers forward or rearward,
loosen the cap screws that attach the upper control
lever to the lower lever. Then, pivot the upper control
lever. Tighten the cap screws. Figure 4-13
B. To lower and raise the control levers, remove the cap
screws. Slide the upper control lever up or down and
align the holes in it with the holes in the lower lever.
Re-install the cap screws and tighten.
The steering control levers should be adjusted so that they
align with each other when in the neutral position.
Use only genuine Hustler
®
replacement blades to
ensure that original standards are maintained.
Failure to use approved blades could lead to blade
breakage which could result in death, injury or
property damage.
48" Rear Discharge Deck
601123 BLADE, 16.50-L-F-CW
796623 BLADE, 16.50"-MUL-F-CW
796631 BLADE, 16.50"-GAT-F-CW
48" Side Discharge Deck
601014 BLADE, F16.50-L-F-CW
795757 BLADE, F16.50"-H-F-CW
796623 BLADE, 16.50"-MUL-F-CW
796631 BLADE, 16.50"-GAT-F-CW
54" Side Discharge Deck
601012 BLADE, F18.50”-L-F-CW
797696 BLADE, F18.50"-H-F-CW
797704 BLADE, 18.50"-MUL-F-CW
797712 BLADE, 18.50"-GAT-F-CW
WARNING
A. Seat release lever
Figure 4-12
A

HUSTLER FasTrak Specifications

General

Brand	HUSTLER
Model	FasTrak
Category	Lawn Mower
Language	English