REV C 5-2 605596CE
Uneven cutting height The blade(s) are not sharp Sharpen the blades
A cutting blade(s) is/are
bent
Install new cutting blade(s)
The deck is not level Level the deck per the Deck
leveling and height adjust-
ment section of the General
Service Manual
An anti-scalp wheel is not
set correctly
Adjust the height of the
anti-scalp wheel
The underside of the deck
is dirty
Clean the underside of the
deck
Tires improperly inflated Adjust air pressure to 55–
83 KPa
A blade spindle mount is
bent
Contact your Dealer
SYMPTOMS PROBABLE CAUSES
SUGGESTED
REMEDIES
To Next Page
Loading...
Need help?
General
