HUSTLER TrimStar User Manual

114510 4-3 REV D
Refer to the Hustler
®
TrimStar
®
General Service Manual (P/N
114674) for complete hydraulic oil and filter change
procedures.
Fuel and Evaporative Emissions Control System
IMPORTANT: Refer to the Safety section of this manual for
fuel handling safety information.
Use only Hustler
®
approved replacement parts.
Your evaporative emission control system may include
parts such as:
• fuel tanks
• fuel lines
• fuel line fittings
• fuel caps
• carbon canisters
• canister mounting brackets
• carburetor purge port connection
• filters
• vapor hoses
• clamps, control valves
• control solenoids
• electronic controls
• vacuum control diaphragms
• purge valves
• liquid/vapor separator
• other associated components
The 5.0 U.S. gallon (18.9 liter) fuel tank is located behind
the engine. Figure 4-4 & Figure 4-5
Park the mower on level ground before filling the fuel tank.
Clean the area around the fuel cap before removing the
cap. Remove the fuel cap slowly.
When threading the fuel cap onto the filler neck, tighten the
cap until it begins to click, then, continue to turn it until at
least three clicks are heard.
IMPORTANT: Do not overfill the fuel tank. If the fuel tank
has a sight glass, the fuel tank should be filled no higher than
to the top of the sight glass. Figure 4-4 Otherwise, the fuel
tank should be filled no higher than the bottom of the fill
neck. Figure 4-5 The fuel system is designed to leave room
for the fuel to expand with fuel temperature changes. Stop
filling the tank after the fuel nozzle automatically clicks off.
Use of replacement parts not equivalent to the
original parts may result in system failure and
pose a safety hazard.
WARNING
A. Fuel tank B. Top of sight glass
Figure 4-4
A. Fuel tank
B. Fuel cap
C. Fuel Neck
Figure 4-5
A
B
A
B
C
IMPORTANT:

HUSTLER TrimStar Specifications

General

Brand	HUSTLER
Model	TrimStar
Category	Lawn Mower
Language	English