4-10
O
PERATION
Operator Manual
1. Tilt the torch and press the start button.
Piercing
• Hold the torch so that the tip is approximately 1/16 inch (1.6 mm) away from the workpiece
before firing the torch. This method maximizes the life of the nozzle.
• Hold the torch at an angle to the workpiece away from yourself, pull back on the trigger and
slowly rotate the torch to an upright position. This is particularly important when cutting thicker
material. Make sure that the torch is pointed away from you and the people near you to avoid
any danger from sparks and hot metal.
• When the pierce is complete, bring the torch head to a perpendicular position and proceed with
the cut.
Figure 4-9 Piercing
2. Rotate the torch to an upright position.
To Next Page
Loading...
Need help?
General
