Hypertherm XPR Series User Manual

Preventive Maintenance Program
XPR Instruction Manual 809480 17
Monthly
Clean inside the plasma power supply
1. Remove the power from the cutting system.
2. Remove the side panels of the plasma power supply and the top panel from both the gas
connect console and torch connect console.
3. Use low pressure air or a vacuum to remove any accumulation of dust and particles from:
 The side panels
 The fans
 The heat exchanger
 The inside of the gas connect console
 The inside of the torch connect console
4. Remove dust and particles from circuit boards.

Be careful not to damage the circuit boards.
5. Install the side panels on the plasma power supply and top panel on both the gas connect
console and torch connect console before you supply power to the cutting system.
WARNING
ELECTRIC SHOCK CAN KILL
Disconnect electrical power before doing any installation or maintenance.
All work requiring removal of the plasma power supply outer cover or panels
must be done by a qualified technician.
See the Safety and Compliance Manual (80669C) for more safety
precautions.

Hypertherm XPR Series Specifications

General

Brand	Hypertherm
Model	XPR Series
Category	Welding System
Language	English