HPK-1000/1500/2000/2500/3000 USER MANUAL 10
4.3 Mounting
1. Use the mounting bracket as a template and mark the drill holes. Drill 2 holes using
a 10mm bit to 70mm depth.
2. Fix the mounting bracket with the screws and expansion bolts packed in mounting
accessories.
3. Attach the inverter to the mounting bracket.
4. Check both sides of the heat sink to ensure the inverter is stably attached.
5. Use M5 screws (T25 screwdriver, torque 2.5 Nm) to attach the heat sink fins to the
mounting bracket.
6. It is recommended to attach the anti-theft lock to the inverter. Lock diameter φ4-
5.5mm recommended.
4.4 Installing the PE cable
1. Insert the grounding conductor into the suitable terminal lug and crimp the contact.
2. Thread the M5 * 13 screw through the terminal lug.
3. Tighten it firmly into the housing (screwdriver type: T25, torque: 2.5Nm).
To Next Page
Loading...
Need help?
General
