4.3 Mounting the inverter with the wall bracket
Mounting procedures:
1. Use the wall bracket as a drilling template and mark the positions of the drill holes.
Drill 2 holes required using a drill with 10 mm bit. The holes must be about 70 mm
deep. Keep the drill vertical to the wall, and hold the drill steady to avoid tilted
holes.
2. After drilling holes in the wall, place two screw anchors into the holes, then attach
the wall mounting bracket to the wall using the self-tapping screws and washers
delivered with the inverter.
3. Holding the inverter and attach it tilted slightly downwards to the wall bracket.
3. Check both sides of the heat sink to ensure that it is securely in place.
To Next Page
Loading...
Need help?
General
