6-37
GENERAL INSTRUCTIONS
Check immediately that any spare parts you receive have not been damaged in shipment.
Always work in a clean environment.
Wash all components in solvent and blow dry with compressed air before refitting.
Take care not to damage rubber seals.
Avoid damaging precision machined surfaces.
Components should fit into their housings without excessive force. If force is necessary, this
normally means that the component does not have the correct dimensional tolerances of is
aligned incorrectly.
When hand pressure is insufficient, only use presses or rubber hammer to fit components.
Never strike components with steel hammers.
Steel bushing must be fitted only with a suitable press.
Do not use hammers to fit bearings.
Always respect the direction of rotation when assembling components.
2)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
To Next Page
Loading...
Need help?
General
