EasyManuals Logo
Home>Hyundai>Forklifts>14BRJ-7

Hyundai 14BRJ-7 User Manual

Hyundai 14BRJ-7
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
1-14
Lifting or jacking any large piece of equipment such as forklift truck presents obvious hazards.
It mu
st be done with great care and forethought.
SAFE PARKING
Before working on truck :
Park truck on a hard, level and solid surface, such as a concrete floor with no gaps or breaks.
Put mast in vertical position and fully lower the forks or attachment.
Put all controls in neutral. Turn key switch OFF and remove key.
Apply the parking brake and block the wheel.
Defective equipment can cause accidents. Al
l tools and lifting equipment must be in good
condition, meet the load capacity requirements and have
OSHA labels when required. Tools
with defects and have failures causing severe injury or death.
LIFTIN
G, BLOCKING AND JACKING
POINTS
Use the following illustration to locate
general lifting, blocking and jacking points
on the truck. Read the procedures for
raising, blocking or jacking specific
components of the truck to make sure you
understand the correct, safe procedures.
Do not attempt to lift the truck by the
overhead guard or the counterwe
ight.
Severe injury may result and the truck
can be damaged.
Under drive
unit mount
Under frame
On tie bars of
mast
Under mast
Front frame
center
14BRJ7OM03
13. LIFTING, JACKING AND BLOCKING
2)
1)
(1)
(2)
(3)
(4)
RAISING TRUCK WITH A HOIST
When suitable equipment is available, the front of the truck may be raised by means of a hoist, with
wheel cradles placed under the wheels or blocking placed under the frame.
When lifting the front of the truck, watch truck for signs of lateral ins
tability. It may tip
sideways. You may have to support or guide the side of the truck or overhead gu
ard to
prevent tipping.
Park truck safely as described in "Safe Parking". Block rear steer wheels.
Check trunnion bolts to make sure they are tightened to correct torque. Bolt torques must be
7.5-8.0
kgfÂm
(55-59ft
Âlb
).
To raise the front of the truck using the mast, spread two chains on the outer rail tiebar the mast.
C
Chain and hoist used to lift truck should be checked to make sure they are of safe lifting
capacity.
See the truck data plate for information.
3)
(1)
(2)
(3)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hyundai 14BRJ-7 and is the answer not in the manual?

Hyundai 14BRJ-7 Specifications

General IconGeneral
BrandHyundai
Model14BRJ-7
CategoryForklifts
LanguageEnglish

Related product manuals