19
Ⅷ
ⅧⅧ
Ⅷ.
..
.
Periodic maintenance and repair:
Comprehensive check for truck can avoid malfunction and ensure the service life. The hours listed in
maintenance procedures is based on the cases that the truck works for 8 hours per day and 200 hours per
month. For the sake of safety, maintenance shall be carried out according to maintenance procedure.
Notice
All the repair work shall be carried out by professional personnel.
Please contact the sales department of our company if you need to adjust or replace the components.
1
11
1 Precautions during maintenance:
Notice
The components for replacement shall be produced completely by our company. When
replacing components of the truck, the components with the same safety requirement
with the original design shall be used.
The lubricating oil and hydraulic oil in use shall be recommended by our company.
⑴
Places for maintenance:
Notice
The places for maintenance shall be appointed and can provide other services such as
hoisting and safety protection facility etc.
The places shall have level ground and good ventilation.
The places shall be equipped with fire-extinguishing devices.
⑵
Precautions before repair and maintenance:
Notice
No smoking.
Arrange the self-protection work.
Wipeout the effusive oil in time.
Before adding lubricating oil, clean up the dirty oil or dust on the joint with brush or cloth.
Except certain situation, turn off the key switch and pull off the power socket.
Lower down the fork arms to the lowest point when carrying out maintenance.
Ensure no goods on the truck when demounting the high pressure oil pipe. Besides, the fork
arms shall be descended to the lowest position, by this way, the pressure of hydraulic system
can be released.
For the reason that there are capacitors storing a little amount of electric energy in circuit, so
before contacting the binding post of the main circuit, discharge at first.
Clean the electric section with compressed air, never flush with water.
When the truck requires high-position maintenance, the altitude safety protection must be
carried out for the repairing and maintenance personnel.
To Next Page
Loading...
Need help?
General
