7. After starting the engine, press the throttle trigger to release the throttle trigger lockout. Let the engine run
for 2 to 3 minutes so that it warms up before subjecting it to any load.
DO NOT use the hedge trimmer in the following conditions:
1.
When the motor rotary speed changes
2. When sparks occur
When blades are damaged
3.
4. In case of misre
In case of high vibration
When ames or smoke appear
In rain or stormy weather
5.
6.
7.
WARNING!
Check the cutting attachment always stops when the engine is idling.
Cutting
During cutting, keep the running speed high, any prolonged use at low speed is likely to cause premature
wear of the clutch.
On the other hand, the user should not keep the engine speed in max speed after cutting. Any prolonged use at
the highest speed is likely to reduce lifetime of engine.
Adjust the throttle setting to suit the load.
When trimming a hedge the engine should always face away from the hedge.
Hold the machine as close to your body as possible to get the best balance.
Make sure that the tip does not touch the ground.
Do not rush the work, but work steadily until all the branches have been cut back cleanly.
CAUTION!
In an emergency, stop the engine by turning the engine switch to the ‘STOP’ position.
CAUTION!
Trim from sides of hedge rst, and then to the top. Cut slowly, especially with thick hedges.
Vertical Cut
Use an arc cutting style from the bottom upwards, then downwards to use both sides of the blades.
Horizontal cut
In order to get the best cutting results, slightly tilt theblade (5-10°) towards the cutting direction.
Kickback and Related Warnings
Kickback is a sudden reaction to a pinched or snagged rotating blade. Pinching or snagging causes rapid stalling
of the rotating accessory which in turn causes the uncontrolled power tool to be forced
www.hyundaipowerequipment.co.uk
11
Operator's Manual
Hyundai HYT2622 & HYT2622-II Hedge Trimmer
To Next Page
Loading...
Need help?
General
