Hyundai i10 Owner's Manual & Service Booklet

5. Disconnect the power connector from
the back of the headlight assembly.
6. Remove the headlight bulb cover by
turning it counterclockwise.
7. Disconnect the headlight bulb socket
connector.
8. Unsnap the headlight bulb retaining
wire by depressing the end and push-
ing it upward.
9. Remove the bulb from the headlight
assembly.
10. Install a new headlight bulb and snap
the headlight bulb retaining wire into
position by aligning the wire with the
groove on the bulb.
11. Connect the headlight bulb socket
connector.
12. Install the headlight bulb cover by
turning it clockwise.
13. Connect the power connector to the
back of the headlight assembly.
14. Reinstall the headlight assembly to
the body of the vehicle.
Position light bulb
1.Remove the socket from the assem-
blyby pulling it out.
2.Remove the bulb by pulling it
straightout.
3.Insert a new bulb into the socket.
4.Install the socket into the assembly
bypushing it in.
Turn signal light bulb
1.Remove the socket from the assembly-
by turning the socket counter clock-
wise until the tabs on the socket align-
with the slots on the assembly.
2.Remove the bulb from the socket
bypressing it in and rotating it until
thetabs on the bulb align with the slots
inthe socket.Pull the bulb out of the-
socket.
3.Insert a new bulb by inserting it intothe
socket and rotating it until it locksinto
place.
4.Install the socket into the assembly
byaligning the tabs on the socket with
theslots in the assembly.Push the
socketinto the assembly and turn the
socketclockwise.
OPA077036 OPA077047
Maintenance
539

Hyundai i10 Specifications

General

Brand	Hyundai
Model	i10
Category	Automobile
Language	English