Quick Reference Guide I 1312I Quick Reference Guide
TUCSON
HYUNDAI
FEATURES AND CONTROLS
Standard Programming
To train most devices, follow these instructions:
1. For the first-time programming, press and hold the two outside buttons,
HomeLink® Channel 1 and Channel 3 buttons until the indicator light
begins to flash (after 10 seconds). Release both buttons. Do not hold
the buttons for over 20 seconds.
2. Position the end of your hand-held transmitter 1-3in. (2-8 cm) away
from the HomeLink® buttons while keeping the indicator light in view.
3. Simultaneously press and hold both the HomeLink® and hand-held
transmitter button. DO NOT release the buttons until step 4 has been
completed.
4. While continuously holding the buttons, the red indicator Status LED will
flash slowly and then rapidly after the HomeLink® successfully trains to
the frequency signal from the hand-held transmitter. Release both
buttons.
For more detailed information, please refer to your Owner’s Manual, or
visit www.homelink.com.
Home Link
HOMELINK WIRELESS CONTROL SYSTEM
REARVIEW CAMERA
When the transmission is shifted into
the R (Reverse), the rearview camera
displays the area behind the vehicle.
SEAT WARMER (front seats)
Each time you press the button, the setting is changed as following:
OFF HIGH MIDDLE LOW
AIR VENTILATION SEATS (front seats)
Each time you press the button, the setting is changed as following:
OFF HIGH MIDDLE LOW
The rear parking assist system assists
the driver during the reverse
movement of the vehicle by chiming if
any object is sensed within a distance
of 47 inches behind the vehicle.
Push the button to turn off the rear
parking assist system. The indicator
light on the button will turn on.
REAR PARKING ASSIST SYSTEM
To Next Page
Loading...
Need help?
General
