2
ELECTRICAL PLANT
The engine is equipped with an analogical ignition with fixed advance, normally set
to 1.1mm (min0.8 max1.4mm) before TDC.
1. SWITCH ON / OFF
2. COIL CABLE
3. COIL
4. IGNITION
WARNING ON THE EXHAUST PLANT
Check that the muffler mounting springs are well hooked. In case of breaking,
replace the broken spring. Do not use the engine if the springs are not correctly
installed, as the muffler may vibrate more than the limit and could break.
It is recommended to remove the rear cup of the muffler every 10/15 hours and
check that the counter-cup holes are not clogged with deposits.
WARNING ON THE INLET SILENCER
Make sure that the inlet silencer is mounted with the inlet hole facing upwards
and that is not blocked in any way. Make sure the inlet silencer clamp on the
carburetor is adequately tighten.
Periodically clean internally the intake silencer.
To Next Page
Loading...
Need help?
General