EasyManuals Logo
Home>IBC>Water Heater>SFT Series

IBC SFT Series User Manual

IBC SFT Series
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
USER’S INFORMATION MANUAL
14
SFT SERIES WATER HEATERS
MAINTENANCE
General Care
Keep combustible materials and ammable liquids and vapours away from the unit.
Keep vent terminals clear of obstructions (snow, dirt, etc.).
Daily Maintenance
Check all the daily maintenance items.
Check the domestic hot water temperature at the faucet to ensure the
temperature is not too hot. If the temperature is too hot, you can adjust the
water temperature with the unit’s controller. If these adjustments are not
correcting the issue, call your qualied service technician for service.
Check the pressure relief valve and discharge piping for signs of leakage
or moisture. If water or moisture is found, contact your qualied service
technician as soon as possible for service.
Regularly check the condensate trap and outlet pipe. The condensate trap
must be full of water. The outlet hose may be connected to a condensate
neutralizer, and if so, check that the pH of the water coming out of the
neutralizer is above 6.0pH. If the pH is below 6.0 then the neutralizer will need
to be re-charged or replaced. Contact your qualied service technician for
service.
Annual Maintenance
The unit must be inspected by your qualied service technician for the following:
Inspect the ue gas exhaust and air intake connections. All connections
should be tight and leak free.
Inspect ue gas exhaust piping, combustion air piping and terminations.
Inspect the unit’s interior and vacuum if required.
Check for water, gas and condensate leaks in the unit and around the unit.
Check the condensate trap and clean if required. Re-ll the trap and re-install.
Check the water pressure.
Check the electrical connections.
Check the ignition electrode and remove oxidation from the electrode.
Replace if necessary.
Check the gas valve and ignition cable.
Check the controller settings.
Check the burner’s ame. Should be a quick and quiet ignition across the full
burner.
If required, clean the heat exchanger and the burner.
WARNING
Annual Maintenance must
only be done by a qualied
service technician.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBC SFT Series and is the answer not in the manual?

IBC SFT Series Specifications

General IconGeneral
BrandIBC
ModelSFT Series
CategoryWater Heater
LanguageEnglish

Related product manuals