Figure 82. Installing the stabilizer bracket
7. Use a #2 Phillips screwdriver to torque the screws to 2.5 N-m (1.84 ft lb).
Connecting the power distribution system
You can use a power distribution system to monitor the individual power loads of the devices that are
plugged into it. Use the procedure in this section to connect this system.
About this task
To connect a power distribution unit, see “Power distribution unit and Intelligent Switched High Function
PDU” on page 53.
Attaching the rack doors
Learn how to attach the rack doors. Use this procedure to perform this task.
About this task
Depending on the model of the rack, the front door of a rack might be an optional feature. If your system
already has the front door installed, or does not have a front door to install, skip this section.
Attaching a front or rear door
You might need to attach a front or rear door to the rack. Use the procedure in this section to perform this
task.
About this task
To install the front or rear door, complete the following steps:
118
Power Systems: Racks and rack features
To Next Page
Loading...
Need help?
General
