To Next Page

To Previous Page

Installing the IBM Power S1014 (9105-41B)

Use this information to learn about installing the IBM Power S1014 (9105-41B) server.

Installing a stand-alone server

Use this information to learn about setting up a stand-alone server.

Prerequisite for installing the stand-alone server

Use the information to understand the prerequisites that are required for setting up the preinstalled

server.

About this task

You might need to read the following documents before you begin to install the server:

• The latest version of this document is maintained online. See Installing the Power S1014 (9105-41B)

(http://www.ibm.com/support/knowledgecenter/POWER10/p10jag/p10jag_roadmap.htm).

• To plan your server installation, see Planning for the system (http://www.ibm.com/support/

knowledgecenter/POWER10/p10jag/p10jag_kickoff.htm.

• To download HMC updates and xes, see the Hardware Management Console Support and downloads

website (https://www14.software.ibm.com/webapp/set2/sas/f/hmcl/home.html).

Consider the following prerequisites before you install the server:

Procedure

1. Ensure that you have the following items before you start your installation:

• Phillips screwdriver

• Flat-head screwdriver

2. Ensure that you have one of the following consoles:

• Hardware Management Console (HMC): To manage POWER10 processor-based systems, the HMC

must be at version 10 release 2.0, or later.

• Graphic monitor with keyboard and mouse.

• Teletype (tty) monitor with keyboard.

Moving the server to the installation site

Learn how to move the stand-alone server to the installation site.

About this task

After you have unpacked your stand-alone server, move the server to the installation site.

Completing inventory for your stand-alone server

Use this information to complete inventory for your server.

About this task

To complete the inventory, complete the following steps:

IBM Power S1014 User Manual

Questions and Answers: