To Next Page

To Previous Page

Control panel cables for the 9009-41A, 9009-42A, or

9223-42H

Find information about removing and replacing the control panel cables in the IBM Power System S914

(9009-41A), IBM Power System S924 (9009-42A), or IBM Power System H924 (9223-42H) server.

Removing and replacing the control panel cable in the 9009-41A, 9009-42A,

or 9223-42H

Find information about removing and replacing the control panel cable in the IBM Power System S914

(9009-41A), IBM Power System S924 (9009-42A), or IBM Power System H924 (9223-42H) server.

About this task

Note: Removing or replacing this feature is a customer task. You can complete this task yourself, or

contact a service provider to complete the task for you. You might be charged a fee by the service

provider for this service.

If your system is managed by the Hardware Management Console (HMC), use the HMC to repair a part in

the system. For instructions, see Repairing a part by using the HMC (www.ibm.com/support/

knowledgecenter/POWER9/p9haj/p9haj_hmc_repair.htm).

If you do not have an HMC, use the following procedures to remove and replace the control panel cable.

Preparing the 9009-41A, 9009-42A, or 9223-42H system to remove and replace the

control panel cable

To prepare the system to remove and replace a control panel cable, complete the steps in this procedure.

Procedure

1. Stop the system. For instructions, see Stopping a system

(www.ibm.com/support/knowledgecenter/

POWER9/p9haj/crustopsys.htm).

2. Identify the part and the system that you are working on. For instructions, see Identifying a

part (www.ibm.com/support/knowledgecenter/POWER9/p9haj/sal.htm).

Use the blue identify LED on the enclosure to locate the system. Ensure that the serial number of the

system matches the serial number to be serviced.

3. Use the blue LED to identify the server.

Ensure that the serial number of the system matches the serial number to be serviced.

4. Label and disconnect the power cords from the system unit.

See Figure 49 on page 52 or Figure 50 on page 53.

Notes:

• This system might be equipped with two or more power supplies. If the removing and replacing

procedures require the system power to be turned off, ensure that all the power sources to the

system are disconnected.

• The power cord (B) is fastened to the system with hook-and-loop fastener (A). If you are placing the

system in a service position after you disconnect the power cords, ensure that you unstrap the

fastener.

IBM Power System 9009-42A User Manual

Questions and Answers: