a) In the navigation area, click the Resources icon , and then click All Systems.
b) Click the system name in which you want to activate the logical partition.
c) Select logical partitions that you want to activate.
d) In the content pane, click Actions > Activate.
e) Click Finish.
• To verify that the logical partition start policy is set to User-Initiated, complete the following steps:
a) In the navigation area, click the Resources icon , and then click All Systems.
b) Click the system name to view details.
c) In the navigation area, click Properties > Other Properties.
d) Click the Power-On Parameters tab.
Ensure that the Partition start policy eld is set to User-Initiated.
Connector locations
Learn about connector locations for servers and enclosures and expansion units.
Enclosure and expansion unit connectors
Learn about connector locations for enclosures and expansion units.
Connector locations for the 5887 disk drive enclosure
Learn about connector locations for the 5887 disk drive enclosure.
Figure 36. Connector locations for the 5887 disk drive enclosure
For more information about the 5887 disk drive enclosure locations, see 5887 disk drive enclosure
locations (http://www.ibm.com/support/knowledgecenter/POWER9/p9ecs/p9ecs_5887loccodes.htm).
For more information about the server locations, see Part locations and location codes (http://
www.ibm.com/support/knowledgecenter/POWER9/p9ecs/p9ecs_locations.htm).
Connector locations for the EMX0 PCIe3 expansion drawer
Learn about connector locations for the EMX0 PCIe3 expansion drawer.
The EMX0 PCIe3 expansion drawer is connected to the host system from the PCIe3 cable adapter on the
server to the PCIe3 6-slot fanout module on the EMX0 PCIe3 expansion drawer.
42
Power Systems: Installing the 5887 disk drive enclosure
To Next Page
Loading...
Need help?
General