Appendix A. Product specifications
This appendix contains the following information:
v “Weight and physical dimensions”
v “Environmental requirements”
v “Facility requirements” on page 34
v “System specifications” on page 35
v “Memory specifications” on page 35
v “Data transmission ranges” on page 36
v “Fibre Channel port specifications” on page 36
v “Serial port specifications” on page 36
v “Power supply specifications” on page 36
v “Supported SFPs and HBAs” on page 37
Weight and physical dimensions
Table 9 lists the weight and physical dimensions of the switch.
Table 9. Physical dimensions and weight of the switch
Dimension Measurement
Height 4.29 cm (1.69 in.)
Width 42.88 cm (16.88 in.)
Depth 30.6 cm (12.07 in.)
Weight 4.2 kg (9.3 lb)
Environmental requirements
Table 10 lists the acceptable environment for both operating and nonoperating
conditions.
Table 10. Environmental requirements
Condition Acceptable range during operation Acceptable range during
non-operation
Temperature -10° to + 40°C (14° to 104°F) -25° to 70°C (-13° to 158°F)
Humidity 10% to 85% RH noncondensing, at 40°C,
with maximum gradient of 10% per hour
10% to 90% RH noncondensing,
at 70° C
Altitude 0 to 3 km (9,842 ft) above sea level 0 to 12 km (39,370 ft) above sea
level
Shock 20 G, 6 ms duration, half sine wave 33 G, 11 ms duration, half sine
Vibration 0.5 G, 5–500 Hz 2.0 G, 5–500 Hz
Air flow High speed: 23 CFM
Low speed: 18 CFM
None required
Note: The -10° to 40° Celsius range applies to the ambient air temperature at the
air intake vents on the nonport side of the switch. The temperature inside
the switch can be up to 80° Celsius during switch operation. If the internal
© Copyright IBM Corp. 2008, 2014 33
To Next Page
Loading...
Need help?
General