Notes:
1. Any of the impact printing fonts can be printed double-wide, double-high, or both
double-wide and double-high unless the dot height is more than 9. With Models
TI1 and TI2, you can not print the character double-high if its dot height is more
than 9. For better print quality with double-high characters, set the printer to
unidirectional print mode. (See “Set or cancel unidirectional printing” on page
133.)
2. User-defined characters greater than 9 dots high can not be printed in
landscape mode.
3. The portrait document print line is 80.35 mm (3.16 inches) long. There are 474
half-dots per line for font A, and 379 half-dots per line for font B. The landscape
print line depends on the size of the document inserted.
4. You can print in two densities on the impact printer: 120 half-dots per inch or
150 half-dots per inch. Refer to the description of bits 0 and 1 in “Set print
mode” on page 129 for information about changing the density.
Updated April 2, 2009
100 SureMark Printers User’s Guide
To Next Page
Loading...
Need help?
General
