where:
n=00 Align Left
n=01 Align Center
n=02 Align Right
n=04 Align Column Right
Default:
n=00
Remarks:
v Values 00, 01, and 02 are only valid at the beginning of a line.
v Tabs are only valid when printing is aligned to the left. If tabs are used
when left alignment is not used, results can be unpredictable. (See “Tab
to next tab stop” on page 160.)
v Alignment is relative to the left margin.
v To use the Align Column Right command:
1. Send the characters that you want to be left aligned.
2. Send the Align Column Right command.
3. Send the characters that you want to be right aligned.
4. Send an end of line command, for example X'0A' or X'0D'.
The printer will return to left aligned after the line is printed.
Limitations for n=04:
v The command is only valid in the cash receipt station.
v This command is not supported for Models TI1 and TI2.
v The command is ignored if the printer is not left aligned when the
command is received.
v If the Align Column Right command is received but the line is filled
before an EOL is received, the filled line is treated as an EOL. There are
usually a few dot positions available, but not enough for a full character.
The column alignment will occur on the few dot positions available.
Set error recovery function
EIA-232 Syntax:
ESCc4n or X'1B63;34;n'
where:
n Selects the function.
Bit # ↓ Function Bit=0 Bit=1
LSB 0 Reserved N/A N/A
1 Reserved N/A N/A
2 Release Print Buffer after Error
Correction
Release Hold
32 Automatic retry on a Home Error Enabled Not Enabled
4 Hold buffer when waiting for a
document
Release Hold
5 Hold buffer after a flip error Release Hold
Default:
n=00
Updated April 2, 2009
140 SureMark Printers User’s Guide
To Next Page
Need help?
General
