Select this choice to view or change the server component settings.
– Adapters and UEFI Drivers
Select this choice to view information about the UEFI 1.10 and UEFI 2.0
compliant adapters and drivers installed in the server.
– Processors
Select this choice to view or change the processor settings.
– Memory
Select this choice to view or change the memory settings.
– Devices and I/O Ports
Select this choice to view or change assignments for devices and input/output
(I/O) ports. You can configure the serial ports, configure remote console
redirection, enable or disable integrated Ethernet controllers. If you disable a
device, it cannot be configured, and the operating system will not be able to
detect it (this is equivalent to disconnecting the device).
– Power
Select this choice to set the Power Restore Policy when power loss occur.
The other two options is for Active Energy Manager and Power Restore
Policy. When in the Power Restore Policy option, you can choose from three
modes
- Always on: System will remain ON once power is restored.
- Restore: Restore system to the same state it was on before power loss
occur.
- Always off: System will remain OFF once power is restored.
– Operating Modes
Select this choice to choose from four options:
- Efficiency: Highest performance per watt.
- Acoustic: Lower acoustic level and lowest power.
- Performance: Highest performance.
- Custom: Customized settings.
– Legacy Support
Select this choice to view or set legacy support.
- Force Legacy Video on Boot
Select this choice to force INT video support, if the operating system does
not support UEFI video output standards.
- Rehook INT 19h
Select this choice to enable or disable devices from taking control of the
boot process. The default is Disable.
- Legacy Thunk Support
Select this choice to enable or disable UEFI to interact with PCI mass
storage devices that are non-UEFI compliant.
– Integrated Management Module
Select this choice to view or change the settings for the integrated
management module.
- POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
- POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
Chapter 3. Configuring the server 53
To Next Page
Loading...
Need help?
General