IBM System x3250 M4 User Manual

- Reboot System on NMI
Enable or disable restarting the system whenever a nonmaskable interrupt
(NMI) occurs. Disabled is the default.
- Commands on USB Interface Preference
Select this choice to enable or disable the Ethernet over USB interface on
IMM2.
- Network Configuration
Select this choice to view the system management network interface port,
the IMM2 MAC address, the current IMM2 IP address, and host name;
define the static IMM2 IP address, subnet mask, and gateway address,
specify whether to use the static IP address or have DHCP assign the
IMM2 IP address, save the network changes, and reset the IMM2.
- Reset IMM2 to Defaults
Select this choice to view or reset IMM2 to the default settings.
- Reset IMM2
Select this choice to reset IMM2.
– System Security
Select this choice to view or configure security settings .
– Network
Select this choice to view or configure the network device options, such as
PXE and network devices.
v Date and Time
Select this choice to set the date and time in the server, in 24-hour format
(hour:minute:second).
This choice is on the full Setup utility menu only.
v Start Options
Select this choice to view or boot to devices, including the startup sequence. The
server starts from the first boot record it finds.
This choice is on the full Setup utility menu only.
v Boot Manager
Select this choice to view, add, delete, or change the device boot priority, boot
from a file, select a one-time boot, or reset the boot order to the default setting.
If the server has Wake on LAN hardware and software and the operating system
supports Wake on LAN functions, you can specify a startup sequence for the
Wake on LAN functions. For example, you can define a startup sequence that
checks for a disc in the CD-RW/DVD drive, then checks the hard disk drive, and
then checks a network adapter.
Note: OPROM configuration utility is only available for emulex 10G card.
v System Event Logs
Select this choice to enter the System Event Manager, where you can view the
POST event log and system-event log.
The POST event log contains the three most recent error codes and messages
that were generated during POST.
The system-event logs contain POST and system management interrupt (SMI)
events and all events that are generated by the integrated management module
that is embedded in the integrated management module.
54 IBM System x3250 M4 Type 2583: Installation and User’s Guide

IBM System x3250 M4 Specifications

General

Brand	IBM
Model	System x3250 M4
Category	Server
Language	English