v The MTM portion of the machine label is the 4-digit MT and 3-digit
model, where model = ’CTO’ (Example: 1829-CTO). The PRODUCT ID
portion of the machine label is the 4-digit MT and 3-digit CMV model
(Example: 1829-W15).
v The PEW record is the 4-digit MT and 3-digit model, where model =
’CTO’ (Example: 1829-CTO).
v eSupport will show both the CTO and CMV machine type models
(Example: 1829-CTO and 1829-W15 will be found on the eSupport site.)
v The HMM will have the 4-digit MT and 3-digit CTO model only
(Example: 1829-CTO). Again, CMVs are custom models and are not
found in the HMM.
General
Announce Variant (GAV)
This is a standard model (fixed configuration). GAVs are announced and
offered to all customers. The MTM portion of the machine label is a 4-digit
MT and 3-digit model, where model = a “fixed model number”, not ’CTO’
(Example: 1829-F1U). Also, PEW, eSupport, and the HMM will list these
products under the same fixed model number.
FRU Identification for CTO, CMV, and GAV products
There are three information resources to identify which FRUs are used to support
CTO, CMV, and GAV products. These sources are PEW, eSupport, and the HMM.
Using PEW
v PEW is the primary source for identifying FRU part numbers and FRU
descriptions for the key commodities for CTO, CMV and GAV products at a MT
- serial number level. An example of key commodities are hard disk drives,
system boards, microprocessors, Liquid Crystal Displays (LCDs), and memory.
v Remember, All CTO and CMV products are loaded in PEW under the 4-digit
MT and 3-digit model, where model = ’CTO’ (Example: 1829-CTO). GAVs are
loaded in PEW under the 4-digit MT and 3-digit model, where model = a “fixed
model number”, not ’CTO’ (Example: 1829-F1U).
v PEW can be accessed at the following Web site:
http://w3-3.ibm.com/pc/entitle
Click on MACHINE LOOKUP, followed by WARRANTY INFORMATION. Input
the MT and Serial number and the list of key commodities will be returned in
the PEW record under COMPONENT INFORMATION.
v Business Partners using Eclaim will access PEW when performing Entitlement
Lookup. Business Partners will enter Loc ID, MT and Serial, and the key
commodities will be returned in the Eclaim record under SYSTEM DETAILS.
v Authorized IBM Business Partners can access Eclaim at the following Web site:
http://wca.eclaim.com
Using eSupport
For Key Commodities (Examples - hard disk drive, system board,
microprocessor, LCD, and memory)
v eSupport can be used to view the list of key commodities built in a particular
machine serial (this is the same record found in PEW).
v eSupport can be accessed at the following Web site:
http://www.ibm.com/pc/support
v To view the key commodities, click on PARTS INFORMATION, then PARTS
LOOKUP. Type in the model type and serial number. The key commodities will
be returned in the eSupport record under PARTS SHIPPED WITH YOUR
SYSTEM.
Chapter 1. About this manual 3
To Next Page
Loading...
Need help?
General