IBM THINKPAD X40 User Manual

Symptom or error FRU or action, in sequence
0182
Bad
CRC2. Enter BIOS Setup
and load Setup
defaults.—Checksum of the
CRS2 setting in the EEPROM
is not correct.
1. Run IBM BIOS Setup
Utility. Press F9, and
Enter to load the default
setting. Then save current
setting by pressing F10.
2. System board.
0185
Bad
startup sequence settings.
Enter BIOS Setup and load
Setup defaults.
1. Run IBM BIOS Setup
Utility. Press F9, and
Enter to load the default
setting. Then save current
setting by pressing F10.
0187
EAIA
data access
error—EEPROM access (read
or write) is failed.
System board.
0188
Invalid
RFID Serialization
Information Area or Bad
CRC2—EEPROM checksum is
not correct (block #0,1).
EEPROM CRC2 is not correct
(block #6).
System board.
Replace
planar. Box serial
number needs to be reinstalled.
0189
Invalid
RFID configuration
information area—EEPROM
checksum is not correct (block
#4,5).
System board.
Replace
planar. UUID needs to
be reinstalled.
0190
Critical
low-battery error
1. Charge the battery pack.
2. Battery pack.
0191
System
Security—Invalid
Remote Change requested.
1. Run IBM BIOS Setup
Utility, and then save
current setting by
pressing F10.
2. System board.
0192
System
Security—IBM
Embedded Security hardware
tamper detected.
System board.
0193
RF
antenna has been
removed—RFID antenna has
been removed, which was once
installed.
RFID model only supervisor
password.
0194
The
computer has been carried
through a security gate—The
computer is carried through the
security gate (portal gate).
RFID model only supervisor
password.
(continued)
Symptom-to-FRU index
60 MT 2369/2370/2371/2372/2382/2386

IBM THINKPAD X40 Specifications

General

Brand	IBM
Model	THINKPAD X40
Category	Desktop
Language	English