Figure 109. Attaching the leader pin to the tape
11. Close the pivot arm 4 of the leader pin attach tool by swinging it over the leader pin so that the C-clip
snaps onto the pin and the tape.
12. Swing the pivot arm open and trim the excess tape 5 so that it is flush with the reattached leader pin
6.
13. Use your ngers to remove the leader pin from the cavity 3 in the leader pin attach tool.
14. Use the cartridge manual rewind tool to wind the tape back into the cartridge (wind the tape
clockwise). Ensure that the leader pin is latched by the pin-retaining spring clips on each end of the
leader pin.
15. Remove the rewind tool.
16. Remove the leader pin attach tool by lifting its end away from the cartridge.
盒式磁带的环境规范和装运规范
盒式磁带的规范：适应、环境和存储。
在使用盒式磁带之前，使它适应操作环境，时间为 24 小时或是防止在磁带机中出现冷凝现象所必需的时
间。 此时间会根据盒带所处环境的极端条件而变化。
在打开之前，盒带的最佳存储箱是原来的装运箱。 塑料包装可以防止盒带上积聚灰尘，并能部分地保护它们
免受湿度变化的影响。
装运盒带时，请将其置于包装盒或密封的防潮袋中，以防止其受潮、受污染和受到物理损伤。 请将盒带置于
装运容器中进行装运，该容器内装有足够的包装材料，对盒带有缓冲作用，并防止盒带在容器内部移动。
第 193 页的表 65 给出 L
TO Ultrium 盒式磁带的操作、存储和装运环境。
IBM Condential
192IBM T
S4300 Tape Library 机器类型 3555： 用户指南
To Next Page
Loading...
Need help?
General
