2. Turn off the server and peripheral devices and disconnect the power cords and
all external cables (see “Turning off the server” on page 16).
3. Align the DIMM air baffle over the DIMMs so that the baffle pin on the left side
of the air baffle aligns with the pin hole next to fan 2 and the baffle pin on the
right side of the air baffle aligns with the pin hole next to fan 5 on the system
board, and lower it into the server.
Air baffle
Replacing the cover
To replace the server cover, complete the following steps:
1. Align the cover over the server (toward the rear of the server) until the cover
edges slip into position over the chassis.
Important: Before sliding the cover forward, make sure that all the tabs on both
the front, rear, and side of the cover engage the chassis correctly. If all the tabs
do not engage the chassis correctly, it will be hard to remove the cover later.
2. Slide the cover forward toward the front of the server until the cover is
completely closed.
Chapter 2. Installing optional devices 55
To Next Page
Loading...
Need help?
General