20
SHUTTING DOWN THE DRY ICE BLASTING MACHINE
When the cleaning task has been completed, the following procedure must be
carried out before the machine is dismantled or stored:
• Empty the hopper.
• Activate the trigger on the blasting gun for a few seconds in order to empty the
system of possible dry ice residue.
• Close the compressed air supply.
• Activate the trigger on the blasting gun for a few seconds in order to
depressurize the system or use the air release valve.
• Turn off the machine (press the ON/OFF button).
• Disconnect the main power supply.
• Open the air release valve to depressure the air side supply.
• Disconnect the compressed air supply.
• It is recommended to disconnect the blasting hose.
CORRECT ORDER IS IMPORTANT!
FIRST disconnect the signal cable,
THEN the blasting hose couplings.
• Avoid kinking the blasting hose, when rolling it up.
EMERGENCY STOP
Activation of the emergency stop button immediately stops the blasting air stream
and the dry ice ow. Before the machine can be restarted, the following procedure
must be carried out:
• Disengage the emergency stop button (twist and release the button).
• Start the machine (press the ON/OFF button).
• Restart the blasting air stream by activating the trigger switch on the blasting
gun.
To Next Page
Loading...
Need help?
General
