12
4
MEMORY OPERATION
■ Memory channel selection
The transceiver has 200 memory channels for storage of
often-used frequencies along with 6-character notes.
q Push [MR] to select memory mode.
• Memory BANK number and memory CH number appears.
Using the [DIAL]:
w Push [BANK], then rotate the [DIAL] to select the desired
memory bank number, then push [BANK] (or [CLR]) to exit
the bank selection mode.
• “BANK” appears.
e Rotate [DIAL] to select the desired memory CH number.
• If no memory channel is programmed in the selected bank, no
memory CH selection is available.
Using the Keypad:
w Push [BANK], then push appropriate digit key (0 to 9) to
select the desired memory bank number, then push
[BANK] (or [CLR]) to exit the bank-selection mode.
• “BANK” appears.
e Push 2 appropriate digit key (00 to 19) to select the de-
sired memory CH number.
• If no memory channel is programmed in the selected bank, no
memory CH selection is available.
Comments appear first when programmed, however, the
transceiver can be programmed by your dealer to show
the operating frequency first. Push [MR] to display the
comment in this case.
■ Transferring memory
contents
This function transfers a memory channel’s contents into the
frequency mode. This is useful when searching for signals
around a memory channel’s frequency.
q Push [MR] to select memory mode.
w Select the desired memory channel to be transferred using
the [DIAL] or keypad.
e Push , then push [MR].
• BANK number and memory CH number disappears as
frequency mode is automatically selected and the mem-
ory contents are transferred.
To Next Page
Loading...
Need help?
General
