Icom IC-M127 User Manual

H Address input mode
In order to place individual calls you must know the 10-digit
address code of the vessel you wish to communicate with.
The IC-M127 can be programmed with up to 10 separate ad-
dress codes. When transmitting an individual call (p. 16) the
address code last programmed is used. If no address codes
have been programmed, the individual call function will not
work,
@While pushing [9] and
[CH/WX], push [PWR] IN to
turn power ON.
*“INDV ADRS” appears for 1 sec.
and address input mode is selected.
@ Rotate the channel selector to
select the address number to
be programmed, “AdO” to
“Ado.”
+“. -"s appear instead of numbers when an address code is not
yet programmed.
@® Push [16] to initiate code input,
then rotate the channel selec- Ad 1
tor to select a number for the 4 &
INDY ADRS
Ast digit. = iat ei i
«Ifa “--” is selected as one of
the digits, the address is invalid.
DIGITAL SELECTIVE CALLING 4
@ Push [HI/LO] to move to
the next digit, then rotate
the channel selector to se-
lect a number.
* Pushing [SCAN] moves
to the left (previous) digit.
* If a mistake is made, push [16]
®.
® To input a name to the set
address, push [NAME],
then set the desired name
with the channel selector,
* Use [HI/LO] and [SCAN] keys to move the cursor.
@®Push [NAME] again to
memorize the name.
and repeat from step
Ad ; |
TESIRED f
WESIRED $31
7TS
Ad :
0 123456 7189
@ Turn power OFF, then ON again to exit the address
input mode.

Icom IC-M127 Specifications

General

Brand	Icom
Model	IC-M127
Category	Transceiver
Language	English