7
4
BASIC OPERATION
Receiving and transmitting
D Turning ON the transceiver
z Rotate [VOL] to turn ON the transceiver.
• The transceiver searches for a satellite.
• When the transceiver is connected and registered to
a satellite, the status “IDLE,” transceiver name, and
Talkgroup name are displayed.
L Rotate Talkgroup selector to select a Talkgroup.
L Push [Last Call] to playback the received call. (p. 9)
L Push [UP] or [DOWN] to display the Talkgroup List.
D Receiving
When receiving, “LISTENING,” and the source
transceiver’s name is displayed, and audio should be
heard.
L Rotate [VOL] to adjust the audio output level.
Last Call
Ignore
00:00
LISTENING
TRANSCEIVER 02
TALKGROUP01
D Transmitting
CAUTION: DO NOT transmit without an antenna.
1. Hold down [PTT].
L “REQUESTING” is displayed while the transceiver
requests a transmission.
2. When “TALKING” is displayed, speak at your
normal voice level.
L You can continuously transmit up to the period of
time allowed by the system.
Last Call
Ignore
00:00
TALKING
TRANSCEIVER 01
TALKGROUP01
D Scan and Ignore
[Scan]
Push to scan a call.
[Ignore]
Push to ignore a received call.
L The Ignore function will be canceled if there are no more
calls for 90 seconds or longer.
NOTE:
• The transceiver receives and transmits using several satellites in the same orbit. Receiving and transmitting may
fail, depending on the satellite position or any obstacles between the transceiver and the satellites.
• Your body can also be an obstacle. Do not hook the transceiver on your waist.
To Next Page
Loading...
Need help?
General
