Clearances of 165mm (6 1/2”) above, 100mm (4”) below,
2.5mm (1/8”) at the sides and 450mm (17 3/4
Bottom clearance
enable the consumer to view the system pressure gauge, and
1.
2.
3.
4.
5.
6.
Note. In normal operation the boiler status display (E) will
show codes:
During normal operation the burner on indicator (F) will remain
RESET PROCEDURE
Logic Code Combi ES is a wall mounted, room sealed,
condensing combination boiler, featuring full sequence automatic
the boiler preheats the incoming cold DHW for additional energy
Logic Code Combi ES is a combination boiler providing both
Safety
Regulations or rules in force.
In your own interest, and that of safety, it is the law that this boiler
In IE, the installation must be carried out by a Registered Gas Installer
It is essential that the instructions in this booklet are strictly followed,
for safe and economical operation of the boiler.
Electricity Supply
Supply: 230 V ~ 50 Hz. The fusing should be 3A.
Important Notes
If the boiler is installed in a compartment then the compartment
If it is known or suspected that a fault exists on the boiler then it
until the fault has been corrected by a Gas
Under NO circumstances should any of the sealed components on
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instructions concerning use of the appliance by a
Children should be supervised to ensure that they do not play with
Engineer or in IE a Registered Gas Installer (RGII) should be called
to investigate and rectify the condition causing this and carry out an
THE BENCHMARK SERVICE INTERVAL RECORD MUST BE COMPLETED AFTER EACH SERVICE
Ideal Stelrad Group is a member of the Benchmark scheme and fully supports the aims of
commissioning of central heating systems in the UK and to encourage the regular servicing of all
FOR ANY QUERIES PLEASE RING THE
IDEAL CONSUMER HELPLINE : 01482 498660
NOTE. BOILER RESET PROCEDURE -
To reset boiler, turn mode control knob to reset position and immediately turn knob back to required setting.
To Next Page
Loading...
Need help?
General