POINTS FOR THE BOILER USER
Note. In line with our current warranty policy we would ask that you check through the following guide to identify any
problems external to the boiler prior to requesting a service engineers visit. Should the problem be found to be other
than with the appliance we reserve the right to levy a charge for the visit, or for any pre-arranged visit where access is
not gained by the engineer.
TROUBLESHOOTING
NO HOT WATER
Check the mains switch (fused
spur) is turned on and ensure
switch mode control knob (D) is
in the summer or winter position
Is water coming out of the hot
water tap when turned on?
NO CENTRAL HEATING
Check the mains switch (fused
spur) is turned on and ensure
switch mode control knob (D) is
in the winter position
Does the boiler operate and
provide central heating?
Check the time settings on the
programmer are as you require
and adjust if necessary
Check the programmer (internal
or external to the boiler) is in
thermostat is turned up
NO HOT WATER OR
CENTRAL HEATING
Check the fused spur is turned
on and ensure switch mode
control knob (D) is in the winter
position
Does the boiler have a display
showing on the front control
panel?
Helpline if your appliance is
Registered Engineer, in IE a
Registered Gas Installer (RGII),
if out of warranty
NO
Engineer or in IE a Registered
Gas Installer (RGII)
NO
is displayed then contact a Gas
IE a Registered Gas Installer
(RGII)
NO
Engineer or in IE a Registered
Gas Installer (RGII)
continued . . . . . .
DISPLAY CODE ON BOILER
DESCRIPTION
OPERATION MODES
To Next Page
Loading...
Need help?
General