IDEAL Logic Heat 30 User Manual

4
Ideal Logic Heat - User’s
DISPLAY CODE ON BOILER
DESCRIPTION
The boiler is in standby mode awaiting either a central heating call or hot water demand.
The boiler has a call for heating but the appliance has reached the desired temperature set
on the boiler.
The boiler is operating in heating mode.
The boiler is operating in frost mode.
continued . . . . . .
OPERATION MODES
YES
POINTS FOR THE BOILER USER
Note. In line with our current warranty policy we would ask that you check through the following guide to identify any
problems external to the boiler prior to requesting a service engineers visit. Should the problem be found to be other
than with the appliance we reserve the right to levy a charge for the visit, or for any pre-arranged visit where access is
not gained by the engineer.
TROUBLESHOOTING
NO CENTRAL HEATING OR
HOT WATER
Check the mains switch (fused
spur) is turned on and ensure
mode control knob (B) is in the
ON position
Does the boiler operate and
provide central heating?
Check the time settings on the
timer are as you require and
adjust if necessary
Check the Timer is in an
“ON” position, and the room
thermostat is turned up
NO
See boiler “Operation Modes”
and “Fault Codes” section. If “0”
is displayed then contact a Gas
Safe Registered Engineer or in
IE a Registered Gas Installer
(RGII)
205862-2.indd 64 27/10/2010 14:43:10

IDEAL Logic Heat 30 Specifications

General

Brand	IDEAL
Model	Logic Heat 30
Category	Boiler
Language	English